John Deere 06: Precleaner 1 Close is OFF when commanded ON by control unit LC2

The Precleaner 1 close is not responding to the command from the control unit LC2. This indicates a failure in the operation of the Precleaner 1 close, which is expected to be ON but is currently OFF.

1. 1

   The status of the Precleaner 1 close

2. 2

   The command signal from the control unit LC2

3. 3

   The affected circuit

1. 1

   Verify the command signal from the control unit LC2 to the Precleaner 1 close.

   Check if the control unit is sending the correct ON signal to the Precleaner 1 close.

2. 2

   Inspect the affected circuit for faults.

   Check for any electrical or mechanical issues in the circuit that connects the control unit to the Precleaner 1 close.

3. 3

   Test the operation of the Precleaner 1 close.

   Manually test the Precleaner 1 close to determine if it is functioning properly when the command is issued.